![]() Only way to do so is via MAIN faders that control the MAIN out to speakers. The issue is that I still cannot control the output of the MIC going to USB. I was able to configure in vMIX the Mic1 and Mic2 using now the Asio4all device and the USB Audio CODEC 1 audio channel. ![]() Installed that, v 2.1.4 although windows 10 pro is not that friendly with this interface. Yeah, looks like Behringer directs you to ASIO4ALL. As you raise the volume to listen on final streamed content there is a hiss in the audio channel that I cannot seem to eliminate it.ĭoes anyone have any recommendation for this setup? I tried to boost it with Equalizer APO and Pace but looks like this is not the proper way to configure this. Would it be better to AUX out channel1 and input that on soundcard of the PC and configure that as an audio input on vmix? This way the mic level is kind of decoupled of the main mix volume I really like to use the USB but the sound level is so low and there is noise too in the line. What is the best way to output a microphone from the mixer to the audio input in vmix? Is that the case? Does that mean I cannot use the USB to connect the mic from behringer to the mic module audio input in vmix? Do I have to install audacity that comes with it in hope to have more adjustments for the audio level? Doesn't the mixer output the mic signal to usb? It appears only master main line out from mixer goes on PC via USB. That means I cannot turn the volume up on main speakers as the volume of mic increases too. Also it appears that the mic level on vmix audio setting depends on master level volumes on mixer which I don't understand why. If I use the gain level on vmix audio settings then I can increase the level on output to -12 to -6db, but as I do so there is noise in the line and you can hear a hiss static noise from the audio stream on output. The bypass USB red button is not pressed and the blue bars on microphone audio settings move up as I speak on mic but they remain -39 -20db. I added an Audio input and selected (Microphone USB codec) that comes from the behringer mixer. Can someone see a problem with this setup? ![]() I'm trying hard to use the USB connectivity of this mixer. So the video imput is the capture HDMI source and that is fine. I'm trying to stream on youtube using a canon vixia hf-G40 via a mgewell HDMI capture dongle. Sure wiresless microphones connected to channel 1 and 2 on mixer. PC running windows 10 pro with latest patches and updates. Hello, there are probably lots of articles I read about this but I still have not found a solution.
0 Comments
Leave a Reply. |